VTech DS6641_-2 Manual - Manual (Page 7)

Getting started
3
Handset battery installation
If the handset will not be used for a long time, disconnect and remove the battery to
prevent possible leakage.
To purchase replacement batteries, visit our website at www.vtechphones.com
or call 1 (800) 595-9511. In Canada, go to www.vtechcanada.com or dial
1 (800) 267-7377.
•
•
IMPORTANT:
Check for a dial tone by pressing
/HOME. If you hear a dial tone, the installation is successful.
If you do not hear a dial tone:
Make sure the installation procedures described above are properly done.
It may be a wiring problem. If you have changed your telephone service to digital service
from a cable company or a VoIP service provider, the telephone line may need to be rewired
to allow all existing telephone jacks to work. Contact your cable/VoIP service provider for
more information.
•
•
Plug the battery connector securely
into the socket inside the handset
battery compartment, matching the
orientation of the engraved label.
1. Place the battery with the label
THIS SIDE UP facing up and the wires
inside the battery compartment.
2.
Align the cover flat against the
battery compartment, then slide it
towards the center of the handset
until it clicks into place.
3. Place the handset in the handset
charger to charge. The CHARGE light
is on when the handset is charging.
4.
CHARGE light
remains on when
charging.
Install the battery as shown below.