Velleman К8077 User Manual
Page 24
24
(I)
- Fix the speaker wires with some glue and trim them to a length of 20cm
- Slide an insulating sleeve over both wires. Solder a connector to both
wires and slide the insulating sleeves over the connector.
- Fix the 4 plastic feet by means of a 23mm screw and put the enclosure
on its feet.
(J) - put the heatsink in place and mark the 10 holes.
- remove the heatsink
- pre-drill the holes with a 1.5mm drill
- connect the red speaker wire to the connector marked 'LS+'
- connect the black speaker wire to the connector marked 'LS-'
- Carefully put the amplifier module in place.
- Fix the heatsink using ten 10mm black screws
Enclosure assembly
See also other documents in the category Velleman Hardware:
- NC3MDL1-B (2 pages)
- NC3MXX (1 page)
- NC5FDL1 (2 pages)
- NC3MDL1 (2 pages)
- EDU01 (32 pages)
- NC5MX (1 page)
- MK166 (1 page)
- К8095 (9 pages)
- VMa02 (4 pages)
- VM8090 (1 page)
- VM116 (32 pages)
- EDU02 (28 pages)
- VM202 (1 page)
- NL4MP (1 page)
- NC3MXX-BAG (1 page)
- VM120 (48 pages)
- VM153 EU (1 page)
- VM119 (32 pages)
- VM133 (24 pages)
- VM148 (24 pages)
- MK155 (1 page)
- VCC6 (20 pages)
- MK179 (2 pages)
- VMa04 (4 pages)
- VM122 (44 pages)
- VM134 (24 pages)
- NAC3FCA (1 page)
- VM121 (32 pages)
- К8048 (15 pages)
- К8048 (14 pages)
- VM150 (1 page)
- VMa01 (4 pages)
- NL4FX (2 pages)
- VM152 (20 pages)
- MK157 (1 page)
- VM112 (4 pages)
- VM130 (20 pages)
- NC3FXX-BAG (1 page)
- MK160 (1 page)
- NC5MDL1 (2 pages)
- VM118r (36 pages)
- VM179 (2 pages)
- VM192ir (2 pages)
- VM138 (40 pages)
- VM160 (20 pages)