Spicer 326837 - Manual (Page 6)

06SE01TBC6298 6
Installation/Assembly
Brake Shoe Installation and Adjustments
All EB (except EB-150-4L) and ES-165 5/6/7/8D, F, L
NOTE: The following procedures are divided into sections,
identified by brake model numbers.
1. See Inspection & Repair / Replacement to verify that
spider camshaft, bracket, and brake adjuster are
serviceable and properly installed.
2. During shoe installation, lubricate:
• Shoe roller recess - one-piece roller.
• Roller I.D. - two-piece roller.
Do Not Lubricate:
• Cam head surface. For efficient operation, this surface
must remain free of oil, grease or other contaminants.
3. Hook ends of new retainer springs into holes in both shoe
tables, hooks pointing out.
4. Position upper and lower shoes around anchor pin. Refer
to Figure 10.
5. Install a new shoe return spring. Refer to Figure 11.
NOTE: On ES-165-D, 1, F, a lever may be required to assist in
hooking shoe return spring.
!
CAUTION: Use only grease conforming to NLGI grade #1,
high-temperature, waterproof.
!
WARNING: The long term effects of non-asbestos fibers,
have not been determined. Therefore, precautions should
be used when handling these materials.
See General Information / Lining Material Warning
With Retainer Springs
Installed, Position
Upper and Lower Shoes
Around Anchor Pin
Figure 10
ES-165-D,L,F Only:
Stetch Spring Using Suitable
Tool Positioned as Shown
Figure 11