Spicer 326837 - Manual

06SE01TBC6298 1
Spicer ®
Axles & Brakes
P/N: SHAIS133
WORK INSTRUCTIONS – DANA KIT PART NUMBER: 326837
Reference:
Kenworth Campaign Number: 01KW7
Kenworth Recall Bulletin Number: C-E-101
Below are work instructions for the replacement of specific tie rod end crosslink and brake assemblies from vehicles equipped with Dana E-1000I
or E-1200I steer axles and Dana ES165-5L ES brakes.
Tie Rod Assembly Replacement
1. Disconnect the tie rod end.
2. If the cross tube is being replaced, count the number of
exposed threads on the tie rod end.
3. Loosen the clamp nut and unscrew the tie rod end.
4. Install new tie rod ends or new cross tube.
NOTE: Cross tube has right-hand and left-hand threads for
corresponding sides of the vehicle.
5. Thread tie rod end into cross tube past the tube split. The
number of threads exposed from the tube should be equal
on both left and right tie rod ends.
6. Tighten the clamp nut to 45-60 ft. lbs. (61-81N€m). Make
sure the tab on the clamp holds the end of the cross tube.
7. Install tie rod end into knuckle tie rod arm. Secure with
slotted nut and tighten to 120-160 ft. lbs. (163-217 N€m).
8. Install the cotter pin in the slotted nut and bend the ends to
secure. If necessary, tighten the nut until the holes align.
9. Adjust toe-in.
NOTE: On tie rods with rotating clamp, position clamp with fastener
away from beam.
The threaded portions of both
tie rod ends must be completely
inserted in cross tube split
Threaded end is not completely
inserted in cross tube split
CORRECT
INCORRECT
Equal threads exposed on
left and right tie rod ends
Figure 1
1
4
3
2
5
1 – Tie rod arm
2 – Tie rod end
3 – Slotted nut
4 – Cotter pin
5 – Position clamp fastener away from beam
Figure 2