How to use this catalog, Companion flanges, Circular type - straight round hole – Spicer Driveline Components Catalog - Companion Flanges User Manual
Page 3
3
J300P-1
HOW TO USE THIS CATALOG
Important: See Safety Information in General Information Section (J300P-GI)
To identify a non- splined companion fl ange, there are nine pieces of required information:
1.
Center hole type (Round or Tapered hole)
2. Type
of
fl ange (Circular or Rectangular)
3. Series
4.
Hole size/ bore diameter
5. Keyway
width
6.
Bolt hole diameter and if the hole is drilled or tapped (drilled-D or tapped-T)
7.
Ground hub diameter (where applicable)
8.
Length of through hole
9.
Flange face to end of hub
Example: to fi nd a 1610 Series circular type companion fl ange with a straight round hole, a 3.500 bore
diameter, a keyway sidth of .875, with .375-24 tapped bolt holes, 6.8750 hub diameter, and the fl ange
face to end of hub dimension of 5.0 (see example below):
1/2.
Find the Circular Type with Straight Round Hole section of this catalog
3. Find
the
1610 Series sub-heading
4.
Find the bore diameter of 3.500
5.
Find the keyway width of .875
6.
Find the tapped bolt hole diameter of .375-24
7.
Find the hub diameter of 6.8750
8. Find
the
fl ange face to end of hub of 5.0000
Locate the part number that matches the dimension of your part: example 5-1-883-1
Be sure to read any notes that are provided.
D
K
C
E
F
Pilot
Flange Companion
Diameter
Face
Flange
Bore
Keyway
F-Female
Hub
to End
Part
Diameter
Width
M-Male
Figure
Diameter
of Hub
Number
Bolt
Hole
Diameter
D-Drilled
T-Tapped
J300P-1
COMPANION FLANGES
Circular Type - Straight Round Hole
1610 SERIES (Continued)
A-6.875 B-6.125 DIA. (8 HOLES)
2.500
.625
6.625 F
1
.375 D
5.250
3.500
5-1-873-6
2.750
.625
6.625 F
1
.375 D
5.250
3.500
5-1-873-7
2.938
.750
6.625 F
1
.375 D
5.250
3.500
5-1-873-8
3.000
.750
6.625 F
1
.375 D
5.250
3.500
5-1-873-9
3.125
—
6.625
F
2 .375-24
T 6.875
5.000
5-1-883
3.500
.875
6.625
F
2 .375-24
T 6.875
5.000
5-1-883-1
Part
Number
1
2
3
4
5
6
7
8
Important Notice: The data listed herein is correct to the best of our knowledge and belief; having
been compiled from reliable and offi cial sources of information. However, WE CANNOT ASSUME
ANY RESPONSIBILITY for possible error.
Footnotes for parts and assemblies that are discontinued, will be discontinued upon depletion of
stock, or not sold separately, are indicated by a symbol next to the part number. Match the symbol
to the appropriate status at the bottom of the page. All other footnotes are located immediately
below the yoke dimensional data.