Ohaus DEFENDER 5000 BENCH SCALES Manual en - Manual (Page 34)

EN-32 5000 Series Indicators
Reset No, Yes
Stable Only Off, On
Auto Print Off,
On Stable (-> Load, Load and Zero),
Interval (-> 0…3600), Continuous,
On Accept
Print Content Result (-> Off,
On, Numeric only),
Gross (-> Off, On),
Net (-> Off, On),
Tare (-> Off, On),
Header ( -> Off, On),
User ID (-> Off, On),
Project ID (-> Off, On),
Scale ID (-> Off, On),
Difference (-> Off, On),
Date and Time (-> Off, On),
Information (-> Off, On),
Application Mode ( Off, On),
Name (-> Off, On),
Layout Format (-> Multiple, Single),
Feed (-> Line feed, 4 Line feed, Form
feed)
List
No, Yes
End Print1 Exit PRINT1 menu
(End Print2) Exit PRINT2 menu
3.9.1 Reset
Set the Print menu to factory defaults.
NO
= not reset.
YES = reset.
3.9.2 Print Stable Data Only
Set the print criteria.
OFF = values are printed immediately.
ON = values are only printed when the stability criteria are met.
3.9.3 Auto Print
Set the automatic printing functionality.
OFF
= disabled.
ON.StAb = printing occurs each time the stability criteria are met.
INtEr = printing occurs at the defined interval.
CONt
= printing occurs continuously.
3.9 Print1 and Print2 Menus
Enter this menu to define printing parameters. Default settings are bold.
NOTE: The Print2 menu is only displayed if a second interface
(RS232 or RS422/RS485) is installed.
NOTE: If the Legal for Trade menu item is set to ON, the following
settings are not reset: Stable