Ohaus DEFENDER 3000 METAL WEIGHING INDICATOR Manual en - Manual (Page 31)

EN-29 3000 Series Indicators
4.6 Application Modes
Only modes enabled in the mode menu will be displayed (refer to Section 3.6).
4.6.1 Weighing
Place the item to be weighed on the scale. The illustration indicates a sample of 1.5 kg, Gross
weight.
Note: To return to the Weighing mode from the other modes, press and hold the Mode button until
WEIGH is displayed.
4.4 Changing Units of Measure
Press and hold the PRINT Units button until the desired measuring unit appears. Only measuring units enabled in the Unit Menu
will be displayed (refer to Section 3.7).
4.5 Printing Data
Printing the displayed data to a printer or sending the data to a computer requires that the communication parameters in the Print
Menu are set (refer to Section 3.8).
Press the PRINT Units button to send the displayed data to the communication port (the Auto-Print Mode in Section 3.8 function
must be Off).
4.6.2 Parts Counting
Use this mode to count parts of uniform weight. The Indicator determines the quantity based on the
average weight of a single part. All parts must be uniform in weight for accurate measurements.
To enter the Parts Counting mode, press and hold the Mode button until Count is displayed.
Average Piece Weight (APW)
When the Mode button is released, Clr.PW Pcs is displayed.
NOTE: If no APW has been previously stored, the Clr.PW display is skipped and the display shows
PUt10Pcs.
Clearing a Stored APW
Press the Yes button to clear the stored APW.