EVS MulticamLSM Version 10.03 - July 2010 Configuration Manual - Manual (Page 63)

Issue
10.03.C EVS Multicam – Version 10.03 – Configuration Manual
EVS Broadcast Equipment SA – July 2010
56
Clips (PUSH)
p.3.3
[F1] Target : SDTI+Gigabit
[F2] Target 1 : Yellow 255.255.255.255
[F3] Target 2 : Brown #04
[F4] Mode : Short
[F5] Receive Pg : 1 2 3 4 5 6 7 8 9 0
[Menu]Quit [Ctr+F]Dft [F9]PgUp [F0]PgDn
3.9.9 T
ARGET
Possible values: SDTI (default), Gigabit, SDTI+Gigabit
This parameter specifies which EVS servers will be listed as possible targets for
push actions when the user selects:
• the default Target 1 and Target 2 in the settings, or
• a target for a specific push action if no default target has been configured.
SDTI: Only SDTI targets will be listed. The servers are listed by
their network system name and number.
Gigabit: Only EVS servers reachable via the GigE network and not
present on the same SDTI network will be listed. The servers
are listed by their GigE server name, and IP Address.
SDTI+Gigabit: First the servers on the same SDTI network connected
through SDTI are listed, then the servers not on the same
SDTI network but reachable via the GigE network are listed.
The ‘Gigabit’ and ‘SDTI+Gigabit’ values are not available if the EVS server does
not have an HCTX GigE board.
3.9.10 T
ARGET
1 & 2
Possible values:
• If the target is present on the SDTI network: network system name and number.
• If the target is present on the GigE network: GigE server name and IP Address.
Default: -------- #--
This parameter specifies which machine(s) on the network clips must automatically
be sent to when the operator uses the PUSH function on the EVS Remote Panel.
The machines defined in this setting are also used as default target for clip
copies.
The users can define two default targets: (F2): Target 1, (F3): Target 2. The clips
will be pushed in sequential order.
If no target is defined in these parameters, the user will be able to define the
requested target when (s)he calls the PUSH function.