3 local xtaccess settings (non xml), Registry settings, 4 miscellaneous – EVS XTAccess Version 1.19 - November 2012 User Manual User Manual
Page 59
XTAccess Version 1.19 – User Manual
EVS Broadcast Equipment – November 2012
Issue 1.19.A
49
The description of each XML tag is described in the ”XML Jobs” document.
9.3 Local XTAccess Settings (non XML)
Some XTAccess settings are not supported by XML. They must therefore be specified in
the local settings of the XML Jobs Scan (see section 7.3.3 ‘XML Scan Settings’ on page
Registry Settings
•
HKEY_LOCAL_MACHINE\SOFTWARE\EVS Broadcast Equipment\Common
\FileWriter NoBuffering: Specific setting to transfer a file without any buffering.
Recommended for writing on a MacOS workstation via network (SMB). (default value
= 0)
•
HKEY_CURRENT_USER\Software\EVS Broadcast Equipment\XTAccess\Max
Transfer Rate: Maximum transfer rate (Bytes/second) for the total amount of backup
jobs (all together).
•
HKEY_CURRENT_USER\Software\EVS Broadcast Equipment\XTAccess\
UpdateStatusXFileIfBackupSuccessful: Update STATUSXFILE in MCCLIPTABLE
when backup is successful
o
0:
Active
o
1:
Not Active
9.4 Miscellaneous
•
Remark 1: EVS, GigE and XTAccess activate time-outs when no data are transferred
within a specific time interval (typically 8 seconds). Typically, backing up a file on a
remote drive via UNC path with throughput lower than 5 Mbits/s per transfer job could
trigger a time-out and then cancel the job. Network and storage must be designed
accordingly.
•
Remark 2: Audio Resolution
o In OP1A and Avid MXF format you can select 16 or 24 bits
o In QT and QT Ref format the audio is saved in 16 bits
o In EVS MXF format the audio is saved in 24 bits