EVS XTAccess Version 1.19 - November 2012 User Manual - Manual (Page 111)

XTAccess Version 1.19 – User Manual
EVS Broadcast Equipment – November 2012
Issue 1.19.A
101
29.2.1 XTAccess.log
XTAccess.log lists all the transactions and actions performed by XTAccess. It provides
detailed information for debugging.
Useful error messages are:
• Error 426: XT Transfer Cancelled due to a disconnection with XT server
• Read Slow: The data block to read has not been reached within a few seconds
(typically 15 seconds).
• Write Slow: The data block to write has not been reached within a few seconds
(typically 15 seconds).
29.2.2 XTAccess_Jobs.log
This log can be used as an as-run log. Each job is listed with useful information:
• Type of job
• Source path or IP address
• Destination path or IP address
• Start and end time
• Status of job
• Error message displayed on XTAccess Monitoring GUI (if any)
29.2.3 XTTransfer.log
Specific log for XTTransfer based on FTP Proxy (XT Copy, Avid Transfer). RPC
commands are listed.
29.2.4 XML_Scan.log
Specific log for the Scan XML. You can see log from the XML engine.
29.2.5 XTAccess_UI.cvs
Specific log where you can find the entire job done by XTAccess.