AASTRA 6730i (Version 2.5 Symbol Keypad) User Guide EN - Manual (Page 177)

Model 6730i IP Phone User Guide 169
Additional Features
UPnP Mapping Lines (for remote phones)
Universal Plug and Play (UPnP) is a standard that uses Internet protocols to enable devices to be
plugged into a network and automatically know about each other. With UPnP, when a user plugs a
device into the network, the device configures itself, acquires a TCP IP address, and uses a
discovery protocol based on the Internet's HTTP or HTTPS URL to announce its presence on the
network to other devices.
This method of device discovery on a network is called “Universal Plug and Play” or UPnP. If you
enable UPnP, and the phone is discovered on the network, port mappings are set up between the
phone and the Internet Gateway Device (IGD) in your network. The phone controls the opening,
closing, and polling of ports on the IGD. HTTP and SIP use a single port each. RTP/RTCP uses a
range of ports.
You can enable the UPnP mappings to specific lines on your phone. You set this configuration
using the Aastra Web UI at Basic Settings->Preferences->UPnP Mapping Lines.
Configuring UPnP Mapping Lines
Use the following procedure to configure the UPnP mapping lines on the IP phone.
1. Click on Basic Settings->Preferences->General.
2. The "UPnP Mapping Lines" field is set to 0 by default. If required, change the setting to a
specific line by selecting a line from the list. Valid values are 0 through 10. The line you select
is the line that your remote phone uses to perform Universal Plug and Play on the network you
are connecting to.
3. Click to save your settings.
Note: UPnP must be enabled on your remote phone before you can configure the
UPnP mapping lines. Contact your System Administrator for more information.
Aastra Web UI