AASTRA 4425 IP Vision (SIP) for MX-ONE User Guide - Manual (Page 25)

Start the Phone – Log On/Off
Dialog 4425 IP Vision 26
LAN access control (network authentication)
Your telephone might require a network authentication to gain
access to the network. In this case you must enter a valid user
identity and PIN or password.
Note: The user identity and password used for the network
authentication is not the same user identity and password
you use to log on. The password is obtained from, and can
only be changed by the system administrator.
z
Enter your user identity.
(The display menu key
Erase , is used to remove a wrong entry.)
Log on Press (see display). z
Enter your PIN or password.
(The display menu key
Erase , is used to remove a wrong entry.)
Note:
The password can be entered with letters or numbers, see
section “ Entering names and numbers ” on page 52 .
The PIN is the same as the Individual Authorization Code.
Only digits can be used as PIN. The PIN must be four digits
or more.
Log on Press (see display).
If your user identity and password are accepted, the phone
continues with the startup procedure.
Note: If your user identity and password are not accepted,
contact your system administrator.
Settings CallList Contacts
LAN access control
Enter user ID:
Erase Log on