AASTRA DT4x2 for MD Evolution User Guide EN - Manual (Page 118)

Alarm
MD Evolution – Cordless DT412 / DT422 / DT432 118
No-Movement and Man Down Alarms
Notes:
This function requires an installed optional alarm module.
The stand-by time will decrease by approximately 25%
when the phone is equipped with the alarm module.
• The No-movement alarm will go off when you have not moved
within a preset time (default 30 seconds).
• The Man down alarm will go off when the phone is tilted more
than 45º for a preset time (default 30 seconds), for example if
you fall.
Before an alarm is activated a warning signal sounds and the
No-movement alarm on
or
Man down alarm on
icon starts to flash. If you do not
cancel the alarm by pressing a key, it is sent and a sensor inside
the phone will alert the preprogrammed number.
To use any of these features, you have to activate them first. You
can do this via the
Settings
menu, see section “ DT4X2 Adjustments ”
on page 125 or by programming the function as a Hot key or Soft
key, see section “ Hot Keys and Soft Keys ” on page 130. 2
Press and hold the preprogrammed Soft/Hot key, to put the
alarm in operation respectively out of operation.
No-movement/Man down alarm
is shown in the display when the alarm is
activated.
The No-movement and Man down alarms can be deactivated for
ten minutes (programmed by your system administrator). When the
warning signal sounds, press the Mute key to deactivate an alarm
for ten minutes.
A parameter in the phone determines whether or not an Acoustic
Localization Signal (ALS) should sound after a No-movement and
Man down alarm. The ALS is silenced by pressing the Mute key.
Make the alarm active again
When the No-movement alarm has been sent, it is made active
again by moving the phone or pressing a key. When the Man down
alarm has been sent, it is made active again by moving the phone
to upright position or pressing a key.