AASTRA 7433ip for MX-ONE User Guide EN - Manual (Page 60)

6/1553-DBC 433 01 Uen D 2012-02-22 60
C ONTACTS
8.2 Adding a Contact
There are three ways to add a contact:
• Manually add a new contact.
• Add a number from the call list.
• Add contact from the web interface, see 14.3.1 Contacts Folder on
page 98.
8.2.1 Adding a New Contact
To add a new contact, do the following:
1. Press .
2. Press more....
3. Select Add new manual input, and press Select.
4. Enter a number, and press OK.
If you make a typing mistake, press the volume down key or more...
and select Erase or Erase all.
5. The new contact is added, with the number saved also as name.
Note: If you would like to edit the name, number or ring signal
for this contact, press more..., and select what to edit. For more
information see section 8.3 Editing a Contact on page 61
6. Press Done to save the new contact.
8.2.2 Adding a Contact From the Call List
To add a contact from the call list, do the following:
1. Press .
2. Press more....
3. Select Add new from Call List, and press Select.
4. Select the number to add as a contact, and press Add.
5. Note: If you would like to edit the name, number or ring signal for
this contact, press more..., and select what to edit. For more infor-
mation see section8.3 Editing a Contact on page 61.
6. Press Done to save the number as one of your contacts.
Note: External number must be preceded with the external access
code. The external number can also be stored by adding the