American Magnetics 4Q06250PS-430 Integrated Power Supply System - Manual (Page 180)

162 Rev. 5
Appendix
Power Supply Details
A.11.1 Model 4Q06125PS Single Unit Electrical Specifications
1
Table A-11 lists Model 4Q06125PS electrical specifications.
1. Details for the stand-alone units are provided for reference only.
Many of the basic power supply parameters will not apply in the
closed loop current feedback system application with the AMI Model
430 Programmer controlling current in the outer loop.
Table A-11. Model 4Q06125PS Electrical Specifications
Specification Rating / Description Condition
OPERATING CHARACTERISTICS
Output Range
E
O Max
±6 Vdc
When connecting active loads, the steady-
state voltage of the active load must not
exceed the maximum voltage rating of the
power supply. Otherwise the overvoltage
protection will shut down the power supply.
I
O Max
±125 Adc
Closed Loop Gain
Voltage Channel 0.6
Current Channel 12.5
INPUT CHARACTERISTICS
Voltage
Nominal 230 Vac
Single phase
Range 176 - 264 Vac
Frequency
Nominal 50 - 60 Hz
>65 Hz, leakage exceeds spec
Range 47 - 65 Hz
Current
176 Vac 9.5 A
Maximum
264 Vac 6.4 A
Power factor 0.99 minimum Nominal output power, source
Efficiency 50% Minimum, source
Switching frequency 50 KHz PFC Stage
EMC (Electromagnetic Compatibility) Compli-
ance
EN61326-1 (1997) Class A equipment
EMC immunity to:
ESD EN61000-4-2 Electrostatic discharge
Radiated RF EN61000-4-3 Radio Frequencies
EFT EN61000-4-4 Electrical fast transient/burst
Surges EN61000-4-5
Conducted RF EN61000-4-6
EMC emissions
Conducted
EN61000-3-2 Harmonics
EN61000-3-3 Fluctuation & flicker
EN55011/CISPR11
0.15 to 30 MHz
Radiated 30 to 1000 MHz
Leakage current 3.5 mA 230 Vac, 47-63 Hz