beautypg.com

Appendix, Mounting template – Garmin GPSMAP 230 User Manual

Page 81

background image

69

SECTION

A

APPENDIX

Installation

To flush mount the GPSMAP 230

1. Remove the four M5 screws from the back of the unit and remove the mounting bracket .

2. Using the mounting template provided in the box, determine the location where you want to

mount the unit and tape the template in place.

3. Using a hammer and center punch, mark the centers of the mounting screw holes.

4. Drill the four 0.25” screw holes, using a 1/4” drill bit

5. Cut the center relief section from the panel.

6. From the front, place the GPSMAP 230 into the relief hole until the unit rests flush against

the mounting surface.

7. Secure the unit to the mounting surface using M5 screws.

Note: For thick mounting surfaces, insert the M5 screws directly thru the four drilled holes

(figure 1). For thin panels, place the mounting bracket on the back side of the panel for
more support (figure 2).

8. Attatch the power/data cable and antenna connectors.

Figure 1

Figure 2

230-235

Clear

ance f

or

G-Char

t Installation

and Remo

v

a

l

1/4" HOLE
4 PLACES

Cut this section

from panel

Cut along bold line to better plan your panel

Mounting template provided in box

Mounting Template

update on 230.qxd 1/12/00 11:23 AM Page 69