Garmin nuLink! 2390 - Manual (Page 80)

Appendix
74 nüLink! 2300 Series Owner’s Manual
My battery gauge does
not seem accurate.
Allow the unit to fully discharge, and fully charge it
(without interrupting the charge cycle).
How do I know my
device is in USB mass
storage mode?
When your device is in USB mass storage mode, a
picture of a device connected to a computer is shown
on the device screen. Also, you should see two new
removable disk drives listed in My Computer.
The device is
connected to the
computer, but it will not
go into mass storage
mode.
1. Disconnect the USB cable from your computer.
2. Turn off the device.
3. Plug the USB cable into a USB port on your computer
and into your device.
The device automatically turns on and goes into USB
mass storage mode.
4. Verify your device is connected to a USB port and not
a USB hub.
I cannot see any new
removable drives in my
list of drives.
If you have several network drives mapped on your
computer, Windows can have trouble assigning drive
letters to your device drives. Refer to your operating
system Help file to learn how to map or assign drive
letters.
My phone will not
connect to the device.
• Select Tools > Settings > Bluetooth. The Bluetooth
field must be set to Enabled.
• Turn on your phone and bring it within 33 feet of the
device.
• Go to www.garmin.com/bluetooth for more help.