Operation – ACU-RITE Micro-Line M User Manual
Page 28
MICRO-LINE
Reference Manual
25
OPERATION
Note:
To select a different hole in the pattern, press the
BOLT USE
key and immediately press the number of the hole you want to
mill. Press “2” on the keypad for Hole 2, “3” for Hole 3, etc.
The holes are numbered counter-clockwise from the start angle.
You can also scroll through the series of holes by pressing the
BOLT USE
key repeatedly.
MLMmanual.QXD 2/12/02 5:01 PM Page 52
This manual is related to the following products: