ACU-RITE Micro-Line M - Manual (Page 26)

23
6. Press the Y key. Enter the bolthole pattern’s center point on the Y-axis.
Use a decimal point and minus (-) sign if necessary.
7. Press the ENTER key.
8. Press the ENTER key again. “Radius” will appear.
9. Enter the radius of the circle pattern. Press
ENTER .
10. Press ENTER again. "START" will appear on
the X-axis display.
11. Enter the start angle of the first hole in
the bolthole pattern. (0 degrees is at the
3 o’clock position.) Use a decimal
point and minus (-) sign if necessary.
12. Press ENTER to complete the pattern.
OPERATION
MLMmanual.QXD 2/12/02 5:01 PM Page 50