Fpc 6104 – Acnodes FPC 6104 User Manual

Page 37

661 Brea Canyon Rd., Suite 3

Walnut, CA 91789

tel: 909.598.7388, fax: 909.598.0218

are subject to change without notice. For latest product information,

please visit Acnodes’ web site at www.acnodes.com.

FPC 6104

10.4” Industrial fanless Panel PC

Step 1: Align the mounting screws on the monitor rear panel with the mounting holes
on the bracket.

Step 2: Carefully insert the screws through the holes and gently pull the monitor down-
wards until the monitor rests securely in the slotted holes (Figure 4-21). Ensure that all
four of the mounting screws fit snuggly into their respective slotted holes.

NOTE:
In the diagram below the bracket is already installed on the wall.

Step 3: Secure the panel PC with the wall-mounting kit. To do this, stick the protective
cushion to the wall-mounting kit first. Then, put the wall-mounting kit on the top panel of
the panel PC. Carefully mark the location of the wall-mounting kit screw holes on the
wall. Drill a pilot hole at the marked location on the wall. Secure the wall-mounting kit to
the wall by inserting a retention screw into the pilot hole on the wall (Figure 4-22). This
step is to avoid the panel PC being pushed apart from the wall-mounting bracket acci-
dentally.