Rmc 7152, Pc 5192 – Acnodes PC 5192 User Manual
Page 69
661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218, www.acnodes.com
© Copyright 2009 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at
RMC 7152
14” short depth server
RMC 7152
14” short depth server
69
PC 5192
19-inch sunlight readable touch panel PC
Serial Port Number [COM1]
Use the Serial Port Number option allows to select the serial port used for remote access.
COM1 DEFAULT
System is remotely accessed through COM1
COM2 System is remotely accessed through COM2
NOTE: Make sure the selected COM port is enabled through the Super I/O configuration menu.
Base Address, IRQ [3F8h,4]
The Base Address, IRQ option cannot be configured and only shows the interrupt address of the serial port listed above.
Serial Port Mode [115200 8,n,1]
Use the Serial Port Mode option to select baud rate through which the console redirection is made. The following configuration
options are available
115200 8,n,1 DEFAULT
57600 8,n,1
38400 8,n,1
19200 8,n,1
09600 8,n,1
NOTE: Identical baud rate setting musts be set on the host (a management computer running a terminal software) and the
slave
Redirection After BIOS POST [Always]
Use the Redirection After BIOS POST option to specify when console redirection should occur.
Disabled
The console is not redirected after POST
Boot Loader
Redirection is active during POST and during Boot Loader
Always
DEFAULT
Redirection is always active (Some OSes may not work if set to Always)