Yamaha PSR-540 - Manual (Page 73)

73
Disk Song Playback
Song Transpose
1
Press the [SONG] button.
2
Press the [NEXT] button to display the Song Menu screen.
• This operation does not
affect the pitch of the
keyboard-played voice(s)
• Changes made to the
transpose setting (on page
30) affect the entire sound of
the PSR-540, including the
song transpose setting.
• Enabling the record mode to
record a User song
automatically resets the song
transpose setting to “0”.
3
Select “S.Trans”.
Use the data dial, the [+/YES] button or the [-/NO] button.
4
Press the [NEXT] button to display the Song Transpose
screen.
5
Set the Transpose value.
Use the data dial, the [+/YES] button, the [-/NO] button or the number buttons
[1]-[0].
The transpose range is from -12 to +12. Each step corresponds to one semitone,
allowing a maximum upward or downward transposition of one octave. A
setting of “0” produces normal pitch.
• Minus values can be entered
by using the number buttons
while holding the [-] button.
6
Press the [START/STOP] to start the song.
7
Press the [START/STOP] button again to stop the song.
• Steps #1 through #5 can be
executed during playback.
SongTranspos= 0
S.Menu =S.Trans
SongTranspos= 4
71