FIAT Bravo - Manual (Page 249)

WINDSCREEN/REAR WINDOW
WIPER
BLADES
Periodically clean the rubber part using special
products; TUTELA PROFESSIONAL SC 35 is
recommended.
Replace the blades if the rubber edge is deformed
or worn. In any case, it is advisable to replace them
approximately once a year. A few simple
precautions can reduce the possibility of damage to
the blades:
❒ if the temperature falls below zero, make sure
that ice has not frozen the rubber against the
glass. Use an antifreeze product to release it
if required;
❒ remove any snow from the glass: in addition to
protecting the blades, this prevents effort on
the motor and overheating;
❒ do not operate the windscreen/rear window
wipers on dry glass.
WARNING
Driving with worn windscreen/rear
window wiper blades is a serious
hazard, because visibility is reduced in bad
weather.
Replacing the wiper blades
Proceed as follows:
❒ lift up the windscreen wiper arm and position the
blade so that it forms a 90° angle with the arm;
❒ press tab A fig. 212 of the coupling spring and
remove the blade to be replaced from the arm;
❒ fit the new blade by inserting the tab into the
special slot in the arm. Make sure that the new
blade is secured in position.
fig. 212 F0Q0662
245
GETTINGTOKNOW
YOURCAR
SAFETY
STARTINGAND
DRIVING
WARNINGLIGHTS
ANDMESSAGES
INANEMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX