FIAT Bravo - Manual (Page 197)

CHANGING A BULB
GENERAL INSTRUCTIONS
❒ Before changing a bulb check the contacts for
oxidation;
❒ Burnt bulbs must be replaced by others of the
same type and power;
❒ after replacing a headlight bulb, always check its
alignment;
❒ when a light is not working, check that the
corresponding fuse is intact before changing
a bulb. For the location of fuses, refer to the
paragraph “If a fuse blows” in this section;
WARNING
Modifications or repairs to the electric
system that are not carried out
properly or do not take the system technical
specifications into account can cause
malfunctions leading to the risk of fire.
WARNING
Halogen bulbs contain pressurised gas,
in the case of breakage they may burst.
fig. 156 F0Q0512
193
GETTINGTOKNOW
YOURCAR
SAFETY
STARTINGAND
DRIVING
WARNINGLIGHTS
ANDMESSAGES
IN AN
EMERGENCY
SERVICINGAND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
CYLINDER REPLACEMENT PROCEDURE
To replace the cylinder, proceed as follows:
❒ disconnect coupling B fig. 156;
❒ turn the cylinder to be replaced anticlockwise
and raise it;
❒ fit the new cylinder and turn it clockwise;
❒ connect coupling B to the cylinder and fit
transparent pipe A in the specific compartment.