FIAT Ulysse - Manual (Page 29)

GETTING TO KNOW YOUR CAR
28
To put the seat back into vertical po-
sition, push it upwards until it clicks
and locks in that position.
“WALLET” POSITION
Side seats
Operate release lever C-fig. 33 and
guide the seat back until the “table”
position is reached; then turn the
tipped seat again until the “wallet” po-
sition illustrated in fig. 36 is reached.
If difficult, use the release lever A –
fig. 34b set rear the seats on the left
side.
To restore the seat normal position,
guide it until it engages the runners on
the floor and place the seat back into
vertical position until it clicks and locks
in that position.
USING THIRD ROW SEATS
To get at the rear seats (third row),
lift lever C-fig. 33 from the outside
and tip the whole seat forward.
To get out of the car, lift lever D-
fig. 32 and tip the seat forward.
When the second row
seat is tipped in “wallet”
position, it is not possible
to transport passengers on the
third row seats, as illustrated on
label fig. 36 placed on the seats
themselves. This is a precaution
to avoid any risk of contact with
the articulation mechanisms of
the seat itself.
To restore the seat normal position,
guide it until it engages the runners on
the floor and place the seat back into
vertical position until it clicks and locks
in that position.
Central seat
Operate release lever A-fig. 34 and
guide the seat back until the “table”
position is reached;
Lift lever B-fig. 35 and guide the
tipped seat until the “wallet” position
is reached.
fig. 35
F0B0292b
fig. 34b
F0B0410b