FIAT Ulysse User Manual

Page 27

GETTING TO KNOW YOUR CAR

IMPORTANT After 5 unsuccess-

ful recalls, the system locks the rela-
tive control which will be restored
when the engine is started.

When the engine is on: press and

keep button 1 or 2 pressed until the
stored position is reached.

FRONT SWIVEL SEATS
(where provided) fig. 28-29-30

The front seats (driver and passen-

ger) can be turned through 180° to
create a “front parlour” effect.

To do this from outside the vehicle,

proceed as follows:

– put the seat back in vertical posi-

tion;

– take the seat “almost completely

forwards”;

– driver’s seat: lift the seat up to the

highest position and adjust the steer-
ing wheel “completely forwards”. The
seats cannot be turned 180° if the
handbrake lever is up. In this case, pull
button B outwards and lower the
lever. The brakes of the vehicle are still
on in this position;

– lift the release lever A and, at the

same time, turn the seat 180° inwards
until the “parlour” effect is reached;
the system makes it possible to re-
leased lever A during the seat rota-
tion.

Reverse the above mentioned pro-

cedure to put the seat back in driving
position.

Before starting off again,

make sure that the seats
are facing the front of the

vehicle and are properly fastened
to their anchorage points. The
seat belts can only be used effec-
tively in this position.

fig. 29 - Electric control versions

F0B0223b

fig. 28 - Mechanic control versions

F0B0290b

fig. 30

F0B0224b