FIAT Idea User Manual

Page 66

SAFETY DEVICES

CORRECT USE OF THE CAR

ARNING

LIGHTS AND MESSAGES

IN AN

EMERGENCY

CAR

MAINTENANCE

TECHNICAL

SPECIFICA

TIONS

INDEX

DASHBOARD AND CONTROLS

Cruising range = Shows the distance in km (or mi)
that the car can still cover before needing fuel,
assuming that driving conditions are kept unvaried.
The display will show “- - - -” in the following cases:
❒ value for range to empty lower than 50 km or fuel

level below 4 litres; in this event before “- - - -”
the message “Warning, limited range” will be
displayed (this message will be displayed also if not
in TRIP COMPUTER mode);

❒ in case of car parked with engine running for a

long period, when the car moves off the range to
empty indication will be displayed again.

Travelled distance = shows the km (or miles)
covered from last reset (*).

Average fuel consumption = shows the average
consumption calculated from last reset (*), this value
can be expressed in l/100 km, km/l or mpg.

Instant consumption = shows the fuel consumption
variation updated every second, it can be expressed in
l/100 km or mpg. In case of car parked with engine
running the display will show “- - - -”. When the car
moves off the instant consumption indication will be
displayed again.

Average speed = shows the average speed of the
car in relation with total time elapsed from last reset
(*) and it can be expressed in km/h or in mph.

Travel time = time elapsed from last reset (*).

(*) Reset can be:

– “manual”, reset is performed by the driver by

pressing the relevant button (see paragraph
“Control buttons”)

– “automatic”, reset is performed when the travelled

distance reaches 9999.9 km or when Travel time
reaches 99:59 (99 hours and 59 minutes)

– after reconnecting the battery.

IMPORTANT Lacking information, Trip computer
values are displayed with “- - - -”. When normal
operating condition is reset, calculation of different
units will restart regularly. Values displayed before the
failure will not be reset (*).

IMPORTANT After battery disconnection/connection
certain displayed values are equal to “- - - -” until
significant data for calculation are available.