Engine starting – FIAT Idea User Manual
Page 223
222
SAFETY DEVICES
CORRECT USE OF THE CAR
W
ARNING
LIGHTS AND MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICA
TIONS
INDEX
DASHBOARD AND CONTROLS
IN AN
EMERGENCY
ENGINE STARTING
EMERGENCY START-UP
If the Fiat CODE cannot deactivate the engine
immobilising system, the
Y
and
U
warning lights
stay on and the engine will not start.
To start the engine the emergency start-up can be
performed.
Read the whole procedure carefully before trying to
carry it out. If you make a mistake, you must turn the
ignition key back to STOP and repeat the whole
operation from beginning.
Proceed as follows:
❒
Read the 5-figure electronic code given on the
CODE card;
❒
Turn the ignition key to MAR;
❒
Press and hold down the accelerator pedal. The
instrument panel warning light
U
will come on for
about 8 seconds and then go out;
❒
Release the accelerator pedal and get ready to
count the flashes of the
U
warning light;
❒
Count the number of flashes that corresponds to
the first figure of the code on the CODE card, then
press the accelerator pedal and keep it there until
the
U
warning light comes on for four seconds
and then goes out; release the accelerator pedal;
❒
The
U
warning light will start flashing again: after it
has flashed the number of times that corresponds
to the second figure on the CODE card, press the
accelerator pedal to the floor and keep it there;
❒
Do the same for the remaining figures on the
CODE card;
❒
Once the final figure has been entered, keep the
accelerator pedal pressed. The
U
warning light
will light up for four seconds and then go out;
release the accelerator pedal;
❒
Rapid flashing of the warning light
U
(for about 4
seconds) confirms the operation has been carried
out successfully;
❒
Start the engine by turning the ignition key from
MAR to AVV.
If however the warning light
U
stays on, turn the
ignition key to STOP and repeat the procedure from
step one
IMPORTANT After an emergency start-up, you should
contact a Fiat Dealership otherwise you will have to
repeat the procedure described each time you want to
start the engine.