FIAT Idea - Manual (Page 272)

BRAKE FLUID
Unscrew cap: check that the fluid level in the reservoir is at maximum.
Fluid level in the reservoir shall not exceed the MAX mark.
If fluid has to be added, it is suggested to use the brake fluid in table
"Fluids and lubricants" (see chapter "Technical characteristics").
NOTE Clean accurately the tank cap and the surrounding surface.
At plug opening, pay maximum attention in order to prevent any
impurities from entering the tank.
For topping up, always use a funnel with integrated filter with mesh equal to or lower than 0.12 mm.
IMPORTANT Brake fluid absorbs moisture, for this reason, if the vehicle is mainly used in areas with a high degree
of atmospheric humidity, the fluid should be replaced at more frequent intervals than specified in the “Service
schedule”.
271
SAFETY DEVICES
CORRECT USE OF THE CAR
W
ARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICA
TIONS
INDEX
DASHBOARD AND CONTROLS
CAR
MAINTENANCE
F0H0213m
Make sure that the highly corrosive brake fluid does not drip onto the paintwork. If it does, wash it
off immediately with water.
Symbol
π
on the container indicates synthetic brake fluid, distinguishing it from
the mineral kind. Using mineral fluids irreversibly damages the special braking
system rubber seals.
WARNING
WARNING
Brake fluid is poisonous and highly corrosive. In the event of accidental contact,
wash the parts involved immediately with neutral soap and water, then rinse
thoroughly. Call the doctor immediately if the fluid is swallowed.