FIAT Idea - Manual (Page 245)

244
SAFETY DEVICES
CORRECT USE OF THE CAR
W
ARNING
LIGHTS AND MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICA
TIONS
INDEX
DASHBOARD AND CONTROLS
IN AN
EMERGENCY
F0H0187m
F0H0188m
REAR LIGHT UNITS
To change the bulb, proceed as follows:
❒ open the tailgate;
❒ turn the fastener (A) counter-clockwise (for the left lid) or clockwise
(for the right lid) and remove the cover;
❒ disconnect the electrical connector (C);
❒ slacken the two fastening nuts (B);
❒ to remove the headlight, pull it in perpendicular direction using the
handle on the headlight;
❒ press the bulb holder tabs and remove it from its housing;
❒ remove bulbs (D) - (E) - (F) - (G) lightly pushing them and turning
them counter-clockwise;
❒ refit the bulb holder and make sure the two tabs are fastened and
then connect the electrical connector (C); drive in the two fastening
nuts (B); refit the cover checking that the tabs are fitted in their seat
and turning the fastener (A) counter-clockwise (for the left lid) or
clockwise (for the right lid) to hook it.
In the event of a failure (burnt-out bulbs) on taillights, brake lights will
switch on dimmed automatically in order to guarantee temporary lighting
at the back of the car.
After replacing the burnt-out bulb the taillights will operate regularly.