Edimax Technology AR-7211B V2 - Manual (Page 9)

9
2. Hardware Installation
Step 1. Connect the ADSL line
Connect the Line interface of the device to the Modem interface of a splitter
using a telephone cable. Connect a telephone to the Phone interface of the
splitter using a telephone cable. Connect the Line interface of the splitter to
your existing, incoming line.
The splitter has three interfaces:
 Line: Connect to a wall phone jack (RJ-11 jack).
 Modem: Connect to the ADSL jack of the device.
 Phone: Connect to a telephone set.
Step 2. Connect the router to your LAN network
Connect the LAN interface of the router to your PC, Hub or Switch using an
Ethernet cable (MDI/MDIX).
Note:
Use twisted-pair Ethernet cables to connect the router to a hub or
switch.
Step 3. Connect the power adapter to the router
Plug one end of the power adapter into a wall outlet and connect the other
end to the 5V interface of the device.
The following diagrams show how to correctly connect the router, PC, splitter
and the telephone sets under two different configurations:
Configuration 1
0 shows the correct connection of the router, PC, splitter and the telephone
sets, with no telephone set placed before the splitter.