Edimax Technology BR-6214K User Manual
Page 9
8
2e) Windows NT
1. Click the Start button and select Settings, then click Control Panel. The Control Panel window will appear.
2. Double-click Network icon. The Network window will appear. Select the Protocol tab from the Network window.
3. Check if the TCP/IP Protocol is on your list of Network Protocols. If TCP/IP is not installed, click the Add button to
install it now. If TCP/IP is installed, go to step 5.
4. In the Select Network Protocol window, select the TCP/IP Protocol and click the Ok button to start installing the
TCP/IP protocol. You may need your Windows CD to complete the installation.
5. After you install TCP/IP, go back to the Network window. Select TCP/IP from the list of Network Protocols and then
click the Properties button.
6. Check each of the tabs and verify the following settings:
•
IP Address: Select Obtain an IP address from a DHCP server.
•
DNS: Let all fields are blank.
•
WINS: Let all fields are blank.
•
Routing: Let all fields are blank.
7. Click OK to confirm the setting. Your PC will now obtain an IP address automatically from your Broadband Router’s
DHCP server.
Note: Please make sure that the Broadband router’s DHCP server is the only DHCP server available on your LAN.
Once you’ve configured your PC to obtain an IP address automatically, please proceed to Step 3.
3) Once you have configured your PCs to obtain an IP address automatically, the router’s DHCP server will automatically
give your LAN clients an IP address. By default the Broadband Router’s DHCP server is enabled so that you can
obtain an IP address automatically. To see if you have obtained an IP address, see Appendix A.
Note: Please make sure that the Broadband router’s DHCP server is the only DHCP server available on your LAN. If
there is another DHCP on your network, then you’ll need to switch one of the DHCP servers off. (To disable the
Broadband router’s DHCP server see chapter 2 LAN Port)
4) Once your PC has obtained an IP address from your router, enter the default IP address 192.168.2.1 (broadband
router’s IP address) into your PC’s web browser and press
5) The login screen below will appear. Enter the “User Name” and “Password” and then click
Note: By default the user name is “admin” and the password is “1234”. For security reasons it is recommended that you
change the password as soon as possible (in General setup/system/password, see chapter 2)