Edimax Technology BR-6214K - Manual (Page 24)

23
Parameters Description
IP address
This is the router’s LAN port IP address (Your LAN clients default gateway IP
address)
IP Subnet Mask
Specify a Subnet Mask for your LAN segment
DHCP Server Status
You can enable or disable the DHCP server. By enabling the DHCP server the router
will automatically give your LAN clients an IP address. If the DHCP is not enabled
then you’ll have to manually set your LAN client’s IP addresses; make sure the LAN
Client is in the same subnet as this broadband router if you want the router to be
your LAN client’s default gateway
IP Address Pool
You can select a particular IP address range for your DHCP server to issue IP
addresses to your LAN Clients.
WINS Server
You can specify the WINS server to assign to DHCP clients.
Provide Real DNS Server
When check this box, DHCP server will provide WAN DNS server to DHCP clients.
Otherwise, DHCP server will provide itself as the DNS server.
Domain from upper DHCP
Enable this to assign the domain name from WAN connection.
Static DHCP leases
Static DHCP leases is for user to statically associate an IP address to a specific
MAC address.
Dynamic DHCP Client List
Dynamic DHCP Client List shows all IP addresses already assigned and the
corresponding LAN PC hostname and their MAC addresses.
Click <Apply> at the bottom of the screen to save the above configurations. You can now configure other advance
sections or start using the router (with the advance settings in place)
2.4 QoS
This router supports various types of QoS – Port-based QoS, Rate Policing QoS, and Guaranteed/Spare Class QoS.
For Port based QoS, user can specify the High/Low queue priority for each Ethernet port and can apply total rate limit to
any port from 128Kbps to 32Mbps or at Full-rate(100Mbps). Flow control can also be enabled/disabled on per-port basis.
For Application based QoS, user can specify a destination port number and associate it with an egress priority (High or
Low). For example, in Fig 35, if user config port 7297 with high priority, then user would experience better service quality
for such flows.
Parameters Description
2.4.1 Port-based QoS User can differentiate packet priority by L4 port number or by physical Ethernet port
number.
2.4.2 Rate Policing QoS
User can specify a L3/4 criterion and associate it with a maximum token (packet
rate or data rate based).
2.4.3 Guaranteed/Spare Class
Your ISP requires PPPoE connection.
QoS