Example of connecting two xxx devices – 3Com V7111 User Manual
Page 38
8
Allocate V7111 endpoints (analog lines) and their corresponding phone numbers to
incoming IP calls by completing these steps:
Click the arrow button next to the ‘Endpoint Phone Number’ label; the ‘Endpoint
Phone Numbers’ screen opens.
Enter the number of a channel, starting with 1, (or a group of channels), under the
‘Channel(s)’ column (for example 1-4 for the first 4 endpoints).
Assign each channel a phone number (for a group of channels, define the first
number in an ordered sequence)
Click
the
Submit
button; the ‘Endpoint Phone Number’ table is automatically
updated.
Click
Quick Setup
; you’re returned to the ‘Quick Setup’ screen.
9
Click the Reset button and click OK in the prompt; the V7111 applies the changes and
restarts. This takes approximately 2 minutes to complete. When the V7111 has finished
restarting, the Power and Ready LEDs on the front panel are lit green.
Example of Connecting Two xxx Devices
Not applicable at this release.
Figure 22
Example of Connecting Two xxx Devices
Not applicable at this release.
38
3Com VCX V7111 Analog Gateway Installation Guide