HP XZ200 - Manual (Page 43)

zt1100/xz200 and xt1500 Series Removing and Replacing Parts 43
Troubleshooting and Self-Repair Guide
Figure 11. Removing the Hard Disk Tray
Reassembly Notes
• Insert the connector end of the drive through the opening in the tray, then lower the drive into
place.
• Carefully slide the hard drive assembly into its compartment. Press firmly to make sure the
connector seats properly.
Important
If you are installing a new hard disk drive, install the factory software and operating system on the
drive before loading any additional software—see “Recovering the Factory Software Installation”
on page 37.
Screws,
M2.5x4mm (2)
Screws,
M2.5x4mm (2)