Xerox Phaser 860 - Manual (Page 9)

Networking Setup Guide 3
Connecting Your Printer to a Network
Connecting Your Printer to a Network
Direct Ethernet Connection to Macintosh or PC
Requirements
■ Two RJ-45, twisted-pair, 10Base-T cables
■
An Ethernet-port hub
Procedure
1. Turn off your computer and the printer.
2. Connect one end of an Ethernet cable to the Ethernet port on your computer. Connect
the other end to the hub.
3. Connect the other cable to the hub and the Ethernet port on the printer.
Note
The printer is not a SCSI device. Do not connect the printer to your computer
through the SCSI ports.
4. Turn on your computer and printer.
5. After the computer and printer are connected, refer to the configuration instructions
for your network type.
3094-73