Moving manually, Operation – Yazoo/Kees ZMKW48172 User Manual
Page 37
English
-
37
OPERATION
Moving Manually
When pushing or pulling the mower, be sure to open
the release valves on both hydraulic pumps.
Always turn off engine before engaging or disengaging
the hydro release. Never attempt to adjust the bypass
linkages with the engine running.
The hydro release valves are located below the seat,
on the front side of the hydro pumps.
Raise the deck into the highest cutting position.
1.
Lift the seat frame assembly to access the
2.
release valves.
Use a
3.
5
/
8
" wrench to rotate bolt counter-
clockwise two full turns to disengage pump.
Repeat the procedure for the opposite pump.
4.
To engage, rotate each pump bolt clockwise
5.
until the bolt is snug. Do not overtighten the
release valve or damage to the hydro pump
could occur.
8011-507
Bypass release valve
WARNING!
No settings or adjustments are to be made
unless the engine is stopped, the park
brakes is engaged and the battery cable has
been removed from the battery.