Yazoo/Kees ZMKW48172 - Manual (Page 18)

English - 18
SETUP AND ADJUSTMENTS
Setup
Uncrate machine.
ROpS Assembly Components
1 - Top loop
1 - Left side post
1 - Right side post
1 - Hardware bag
2 - Latch Pins w/lanyard
6 - Cap screws
6 - Centerlock nuts
2 - Knobs
(all hardware Grade 5).
1. Remove roll bar and parts bag from the box.
2. Install roll bar side posts.
a. Locate the LEFT and RIGHT side posts.
b. Slide the left side post into the left side
receiver on the frame, do the same on the
right side.
c. Using the cap screws, two per post, align
the holes in the side post with the frame
receiver. Install the centerlock nuts finger
tight to the side post bolts.
3. Install roll bar top loop.
a. Align the holes of the top loop with the left
and right side posts.
b. Slide the latch pins through the front hole
on the left and right side to connect the top
loop to the side posts and secure with the
hairpin.
c. Insert cap screws through the rear hole on
the left and right side. Install the centerlock
nuts finger tight.
4. Torque all hardware to 80 ft./lbs. (110 N•m).
5. Install and tighten knobs against the side post.
6. If ROPS has been installed correctly, the unit
should fold to the rear of the machine when not
in use.
LATCH PIN
½" CAPSCREW
KNOB
½" CENTERLOCK NUT
LEFT SIDE
POST
RIGHT SIDE
POST
TOP LOOP
½" CENTERLOCK
NUTS
½" CAPSCREWS
WARNING!
No settings or adjustments are to be made
unless: Engine is stopped, key has been
removed, park brake is on and battery cable
removed from battery.