Yazoo/Kees ZMKW48172 - Manual (Page 28)

CONTROLS
English - 28
Mower Deck Cut Height Lift Lever
The lifting lever is used to place the mower deck in
the transport position or one of the 14 different cutting
height positions.
The cutting height is set by placing a peg in the hole
for the desired cutting height and the peg is then
locked on the inside (hidden in the illustration) with the
supplied pin.
To raise the deck to the transport position, pull 1.
the lever backward to the locked position to
engage the transport position.
To lower the deck, pull the lock handle to the 2.
lifting lever and push forward toward the peg to
engage the set cutting height.
The lifting lever can also be used to temporarily 3.
adjust the cutting height, such as when passing
a minor bump in the lawn.
Some models are equipped with an optional foot assist
pedal for ease of deck maneuvering.
8011-525
1. Transport Lock
2. Height selection peg
3. Lock handle
4. Lifting lever
Cut height lift lever
1
4
3
2
IMpORTANT INfORMATION
In order to obtain an even cutting height it is
important that the air pressure in all four tires
is the same 15 psi (1 bar).
IMpORTANT INfORMATION
Always use the high position to transport.
IMpORTANT INfORMATION
The cutting height range is from 1½" (38 mm)
to 5" (127 mm) in ½" (13 mm) increments. The
heights are measured from the ground up to
the blade tip with the engine not running.