Yazoo/Kees ZMKW48172 - Manual (Page 19)

English - 19
SETUP AND ADJUSTMENTS
Tires
Mount rear drive wheels using the lug nuts installed
on the hubs.
Check the tire pressure in all four tires. All tires should
be 15 psi.
Control Arms
Remove top bolt in control arm and loosen bottom
bolt, rotate the control levers to the upright position.
Align the levers so they are even in the neutral
position. Reinstall hardware and tighten.
Seat Install
1. Remove seat assembly from the crate.
2. Remove the four nuts from the bottom of the
seat. Retain for use later.
3. Align the seat bottom with the holes in the seat
frame. Place seat on top of the seat frame and
secure with the four nuts or knobs removed in
Step 2.
4. Connect the wire harness from the seat to the
frame harness.
Engine Oil
Check engine oil with dip stick. Add if needed per
the engine manufactures specifications. See engine
manual for oil type and filling specifications.
Motion Control Lever
Control Arm
“F” Full
Mark
Operating
Range