Yazoo/Kees ZMKW48172 - Manual (Page 20)

English - 20
SETUP AND ADJUSTMENTS
Cutting Height
1. Stop the mower and disengage the blades.
2. Raise the deck height lever to the transport
position.
3. Remove the height adjustment pin and place it
in the desired cutting height hole. Lower the lift
lever down onto pin.
NOTE: Anti-scalp rollers must be in the proper
position for maximum deck flotation.
See the decal on the front deck for
proper settings.
Lift Lever
Deck Height
Adjustment Plates
Mower Deck Leveling
1. Position machine on a flat surface. Preferably
level concrete.
2. Check the tire pressure in all four tires. Inflation
should be 15 psi.
3. Place 2x4s on edge under the cutting deck
from front to rear and lower the deck down onto
2x4s.
4. Adjust the four upper chain bolts to the center
slots in the deck lift arms.
NOTE: Make sure the lift blocks under the
frame are tightly bolted to the frame.
5. Check the chains for equal tension. If unequal
adjust upper chain bolt in slot.
6. Place the deck in the 5" cutting height and
measure from the cutting edge of the blade to
the flat level surface to check the deck cutting
height.
Throttle Lever Tension
Stop engine and remove key.
Throttle lever tension may be adjusted by tightening
the pivot bolt. The pivot bolt secures the throttle arm to
the mounting bracket which is mounted to the console.
Access is gained by removing the console.