ZyXEL Communications Prestige 650H-E Series - Manual (Page 10)

Prestige 650H-E
10
The Prestige automatically logs you out if it is left idle for five minutes;
press ENTER to log back in again.
4.2 Common Screen Command Buttons
The following table shows common command buttons found on many web configurator screens.
Back Click Back to return to the previous screen.
Apply Click Apply to save your changes back to the Prestige.
Reset/Cancel Click Reset or Cancel to begin configuring this screen afresh.
4.3 Internet Access Using the Wizard
Use the Wizard Setup screens to configure your system for Internet access settings and fill in the
fields with the information in the Internet Account Information table. Your ISP may have already
configured some of the fields in the wizard screens for you.
Step 1. In the Site Map screen click Wizard Setup to display the first wizard screen.
Figure 6 Wizard Screen 1
From the Mode drop-down list box, select Routing
(default) if your ISP allows multiple computers to
share an Internet account. Otherwise select Bridge.
Select the encapsulation type your ISP uses from the
Encapsulation drop-down list box. Choices vary
depending on what you select in the Mode field.
Select the multiplexing method used by your ISP from
the Multiplex drop-down list box.
Enter the correct Virtual Path Identifier (VPI) and
Virtual Channel Identifier (VCI) numbers supplied by
your ISP in the VPI and VCI fields. These fields may
already be configured.
Click Next.
Step 2. The second wizard screen varies depending on what mode and encapsulation type you
use. All screens shown are with routing mode. Configure the fields and click Next to
continue.