Xerox 50 LP/ST - Manual (Page 97)

Step 2. Customize Printer Connectivity Settings 6-11
5 If the IP Address Resolution is Static, make sure that the IP Address,
Host Name, Subnet Mask, and Gateway Address are set to the correct
values. If the IP Address Resolution is DHCP, these fields will be read-
only.
6 Click Apply New Settings if any changes were made.
7 Provide a User Name and Password when prompted. (The default User
Name is Admin with a capital "A" and the default Password is 11111.)
8 Power off and power on the copier/printer. Allow at least 30 seconds
between powering off and powering on the printer. A Configuration
Report will print in approximately 5 minutes. The information on the
Configuration Report can be very helpful in completing the network
installation and troubleshooting problems with your copier/printer.
9 Continue with Step 3 Print a Test Page.