Zebra Technologies PrintServer - Manual (Page 85)

74 PrintServer II User and Reference Guide
Printing Configurations
System V Queue Installation
System V Queue Installation
Configuring System V for ZebraNet Printing
This section describes the configuration of the printing system on the UNIX operating
system. For clarity and brevity, the following specific names are used to represent
general devices or concepts.
lj4 —The local queue name on the UNIX system that PSII print jobs are directed to.
ZEBRAPRINTER —The host name of the remote system that is the PSII device. For
example, to Telnet to the PSII and invoke the PSII configuration utility, you would
enter:
Telnet ZEBRAPRINTER
A host name is not required for the PSII – the IP address can be used.
yourqueuename —This is the name of the queue on the ZebraNet and must end
with 1, 2, 3, or 4, depending on the port selected to service the print jobs. If FF, LF or
NF are the last two letters of the queue name, the job is converted accordingly.
Prerequisites
Before you proceed, the following prerequisites must be met:
• The name ZEBRAPRINTER and the IP address assigned to the
PSII are in the /etc/
hosts file on the UNIX system.
• The LPD must be running on the UNIX system.
UNIX Configuration
To configure the UNIX machine so users can spool print jobs to
the PCL print queue on the ZebraNet named ZEBRAPRINTER,
complete these steps:
1. Login to the UNIX machine as root.
2. Type lpsystem -t bsd ZEBRAPRINTER.