Zebra Technologies PrintServer - Manual (Page 32)

Installation
External PSII
PrintServer II User and Reference Guide 21
This illustration calls out the location of the parallel port and provides a blown up
illustration of the parallel port:
3. Secure the wire locks.
4. On the back of the PSII , insert a live 10BASE-T cable into the Ethernet connector.
5. Power on the printer.
An red status indicator blinks during the POST (Power On Self Test) and changes
to green when stabilized.
6. Press the test button located on the side of the PSII . This prints out a configuration
label of PSII:
Note • To determine the minimum label width needed to print a PSII configuration
label, refer the following list of printhead resolutions:
• 600 dpi (1.25 inch)
• 300 dpi (2.50 inch)
• 200 dpi (3.69 inch)
• 150 dpi (5.0 inch)