Zebra Technologies PrintServer - Manual (Page 148)

Frequently Asked Questions
FAQs
PrintServer II User and Reference Guide 137
Will the ZebraNet PSII allow
connectivity to anything other
than a PC network?
Yes.
The ZebraNet PSII allows connectivity to
systems such as IBM’s AS400, provided that
it is configured using TCP/IP. Other network
protocols can be used with third party
adapters that are converted to 10BASE-T.
Will the ZebraNet PSII option
work on a 10BASE-T per second
network?
No.
The ZebraNet PSII option is a 10BASE-T
print server. This means that the data cannot
travel any faster than 10 megabits per second.
The ZebraNet
PSII can be deployed on a
network that is utilizing 10/100 hubs, but the
ZebraNet
PSII operates only at 10 megabits
per second.
What if a print job makes it to
the queue, but never leaves the
queue? The label does not print. These are the things to check:
• Confirm that the printer is turned on and
receiving power.
• Confirm that the network cable is plugged
in and that you can ping the printer.
If the above bullets do not change the
outcome, it is likely that there was a
misconfiguration while creating the queue.
The queue must be recreated verifying the
following:
• Confirm that you use the print servers valid
IP address.
• If you are using a UNIX or AS/400 host,
there is an option for the remote queue name.
There is only one valid response to use:
PORTLF1.
• If Windows does not have LPR installed
the above required option should be left
blank.
• See the documentation for other operating
system specific queue creation.
Question Answer