Zebra 105SL User Manual
Page 94
Configuration
Control Panel Parameters
86
11342L-001 Rev. A
105SL User Guide
6/30/06
Initialize Flash Memory
This option erases all previously stored information from Flash memory.
Caution • This option completely erases the Flash memory.
To initialize Flash memory:
1.
Press
PLUS (+)
to select
YES
.
If your printer is set to require a password, you are prompted to enter
the password.
2.
Enter the password. For instructions, see Change Password-Protected
Parameters
.
The display shows
INITIALIZE FLASH?
3.
Press
PLUS (+)
to select
YES
.
The display shows
ARE YOU SURE?
.
4.
Do you wish to continue?
• Press
MINUS (-)
to select
NO
to cancel the request and return to the
INITIALIZE FLASH
prompt.
• Press
PLUS (+)
to select
YES
and begin initialization.
When initialization is complete, the printer automatically exits Setup
mode, and the control panel displays
PRINTER READY
. If you exit
Setup mode while initialization is still in process, the control panel
display flashes between the phrases
CHECKING E: MEMORY
and
PRINTER IDLE
.
Note •
Depending on the amount of free FLASH memory,
initialization may take up to 1 minute to complete.
Table 9 • Printer Parameters (Page 8 of 19)
Parameter
Action/Explanation
INIT FLASH MEM.
YES