Zhone Technologies 800 - Manual (Page 28)

2-8 IMACS System Release 5.1.6 Server Cards
Model No. Running Head ACS-FRS Card User Screens and Settings FRS Card
2.3.2 Frame Relay Endpoints Screen
You can have up to four frame relay endpoints (two for the actual endpoints of the PVC and
two that can act as backup should the primary link fail). All frame relay endpoints are
inventoried on the Frame Relay Endpoints Screen, and all endpoints must be defined from this
screen before the user can provision the circuit.
Figure 2-3 shows a typical Frame Relay Endpoints Screen, which can be viewed by pressing
“e” (Endp) in the ACS-FRS Card Main Screen. Table 2-3 lists the actions you can perform
from the bottom line of this screen.
Figure 2-3.Typical Frame Relay Endpoints Screen
In Figure 2-3 above illustrates the frame relay endpoint screen for two voice circuits
terminated on port 01, and 02 transported over port “C1” via the HSU to the remote device.
Figure 2-3 also shows the three IP endpoints defined on C1 towards the remote device, and on
C2 towards the IPR.