1 reload the configuration file, 7 logging out of the web configurator – ZyXEL Communications ZyXEL Dimension ES-2048 User Manual
Page 54

Chapter 4 The Web Configurator
ES-2048 User’s Guide
54
4.6.1 Reload the Configuration File
Uploading the factory-default configuration file replaces the current configuration file with the
factory-default configuration file. This means that you will lose all previous configurations
and the speed of the console port will be reset to the default of 9600bps with 8 data bit, no
parity, one stop bit and flow control set to none. The password will also be reset to “1234” and
the IP address to 192.168.1.1.
To upload the configuration file, do the following:
1 Connect to the console port using a computer with terminal emulation software. See
for details.
2 Disconnect and reconnect the Switch’s power to begin a session. When you reconnect
the Switch’s power, you will see the initial screen.
3 When you see the message “
Press any key to enter Debug Mode within 3
seconds ...
” press any key to enter debug mode.
4 Type
atlc
after the “
Enter Debug Mode
” message.
5 Wait for the “
Starting XMODEM upload
” message before activating XMODEM
upload on your terminal.
6 After a configuration file upload, type
atgo
to restart the Switch.
Figure 17 Resetting the Switch: Via the Console Port
The Switch is now reinitialized with a default configuration file including the default
password of “1234”.
4.7 Logging Out of the Web Configurator
Click Logout in a screen to exit the web configurator. You have to log in with your password
again after you log out. This is recommended after you finish a management session for
security reasons.
Bootbase Version: V3.1 | 07/06/2007 18:36:17
RAM:Size = 64 Mbytes
DRAM POST: Testing: 65536K OK
DRAM Test SUCCESS !
FLASH: Intel 64M
ZyNOS Version: V3.80(AID.0)b2 | 07/31/2007 20:43:39
Press any key to enter debug mode within 3 seconds.....................
Enter Debug Mode
ES-2048> atlc
Starting XMODEM upload (CRC mode)....
CCCCCCCCCCCCCCCC
Total 393216 bytes received.
Erasing..
................................................................
OK
ES-2048> atgo