ZyXEL Communications P-660H-T Series - Manual (Page 85)

P-660H/HW-T Series User’ Guide
Chapter 5 Wireless LAN 84
5.7.4 Authentication Required: WPA-PSK
Select Authentication Required in the Wireless Port Control field and WPA-PSK in the
Key Management Protocol field to display the next screen.
See Section 5.6 on page 77 for more information.
Figure 29 Wireless LAN: 802.1x/WPA:WPA-PSK
The following table describes the labels not previously discussed.
Table 18 Wireless LAN: 802.1x/WPA: WPA-PSK
LABEL DESCRIPTION
Key Management
Protocol
Choose WPA-PSK in this field.
Pre-Shared Key The encryption mechanisms used for WPA and WPA-PSK are the same. The
only difference between the two is that WPA-PSK uses a simple common
password, instead of user-specific credentials.
Type a pre-shared key from 8 to 63 printable characters (including spaces;
alphabetic characters are case-sensitive).
WPA Mixed Mode The Prestige can operate in WPA Mixed Mode, which supports both clients
running WPA and clients running dynamic WEP key exchange with 802.1x in the
same Wi-Fi network.
Select the check box to activate WPA mixed mode. Otherwise, clear the check
box and configure the Group Data Privacy field.